1684
Comment:
|
2268
|
Deletions are marked like this. | Additions are marked like this. |
Line 28: | Line 28: |
'''Set the banner to show the name of the switch''' {{{ Switch# configure terminalThe // at the end of the line indicates the start of a comment: Switch# banner login # You are logged into RXSY # Switch# exit Switch# show running //validates that it worked }}} {{{ Switch# show interface status //show status of all the ports Switch# show interface eth-0-49 //shows the status of eth-0-49 }}} |
|
Line 29: | Line 43: |
{{{ Switch# configure terminal Switch# |
|
Line 48: | Line 65: |
'''Show Port Status''' |
|
Line 51: | Line 70: |
}}} '''Show VLAN information for port''' {{{ switch# show interface switchport interface eth-0-1 |
fs.com Switches purchased in 2021
Below is the commands used to configure the switches we purchased in 2021
Initial Setup Notes for 5800 Series Switches
SSH into the switch with the default user:pass = "admin:admin"
First Change the password, note that we are using local authentication mode, not "aaa" mode. What is aaa mode? That's for authenticating against a radius/TACACS+ server.
Switch# configure terminal Switch(config)# line vty 0 7 Switch(config-line)# login Switch(config-line)# line-password abc Switch(config)# exit
Set the time
Switch# configure terminal Switch(config)# clock set datetime 11:30:00 10 26 2013 Switch(config)# clock set summer-time dst date 3 13 2022 02:00:00 11 6 2022 02:00:00 120 Switch(config)# exit
Set the banner to show the name of the switch
Switch# configure terminalThe // at the end of the line indicates the start of a comment: Switch# banner login # You are logged into RXSY # Switch# exit Switch# show running //validates that it worked
Switch# show interface status //show status of all the ports Switch# show interface eth-0-49 //shows the status of eth-0-49
Create VLANs
Switch# configure terminal Switch# '''Setup Management Interface''' Setup management on a vlan interface {{{ switch# configure terminal switch(config)# interface vlan 10 switch(config)# ip address 10.10.129.X/24 switch(config)# Ctrl+z Switch# show management ip address
Common Commands
The // at the end of the line indicates the start of a comment:
Show Port Status
Switch# show interface status //show status of all the ports Switch# show interface eth-0-49 //shows the status of eth-0-49
Show VLAN information for port
switch# show interface switchport interface eth-0-1
Backup and Restore the switch Configuration
To backup the configuration, ssh into the switch and perform the following:
Switch# copy flash:/startup-config.conf mgmt-if scp://10.10.129.X/startup-config.conf
To download a configuration file:
Switch# copy mgmt-if scp://10.10.10.163/startup-config.conf flash:/startup-config.conf